Drop Shackles for a Sierra
~~~~~~~~~~~~~~~~~~~~~~~~~~

Attached is the .dwg file you'll need to give whoever is going to cut your shackles.

Its preferable to have them laser cut out of 4mm steel.

You'll also need to buy 4x high tensile 14mm dia. by 90-100mm long pins with
nyloc bolts for the centre pinning. You can recycle the other pins -
although im getting some new ones which are a bit longer. Youll see
what i mean when u build yours! =) 

Ciao for now

>>>>>>>>>>>>>>>>>>>>>>>
Aron [Alien] Dobrowolski
http://ii.net/~alien
ICQ: 119588300
>>>>>>>>>
